ATOM-MIC POWER
Test class according to EN 61643-11:2012 (IEC 61643-11) |
TYPE 1+2, CLASS I+II |
|
Network type |
TN-S |
|
Maximum continuous operating voltage |
UC |
275 V AC / 350 V DC |
Impulse discharge current for class I test (10/350) L/N |
limp |
25 kA |
Charge L/N |
Q |
12,5 As |
Specific energy for class I test L/N |
W/R |
156 kJ/Ω |
Impulse discharge current for class I test (10/350) N/PE |
Iimp |
100 kA |
Charge N/PE |
Q |
50 As |
Specific energy for class I test N/PE |
W/R |
2500 kJ/Ω |
Total discharge current (10/350) L1+L2+L3+N->PE |
Itotal |
100 kA |
Nominal discharge current for class II test (8/20) |
In |
25 kA |
Maximum discharge current |
Imax |
50 kA |
Total discharge current (8/20) L1+L2+L3+N->PE |
Itotal |
200 kA |
Voltage protection level |
Up |
< 1,2 kV |
Temporary overvoltage (TOV) L/N |
UT |
335 V/5 s |
Temporary overvoltage (TOV) N/PE |
UT |
1200 V/0,2 s |
Response time L/N |
tA |
< 25 ns |
Response time N/PE |
tA |
< 100 ns |
Max. back-up fuse |
250 A gL/gG |
|
Max. back-up fuse („V“ connection) |
125 A gL/gG |
|
Short-circuit current rating at max. back-up fuse |
ISCCR |
80 kArms |
LPZ |
0-1 |
|
Housing material |
Polyamid PA6, UL94 V-0 |
|
Degree of protection of enclosure |
IP20 |
|
Operating temperature |
ϑ |
-40°C ... +80 °C |
Cross-section of the connected conductors (at tightening moment of clamps 3 Nm) |
35 mm2 (solid) |
|
Method of assembly |
DIN rail 35 mm |
|
Failure signalisation (S) |
pushed in - ok / pushed out - failure |
|
Potential free signal contact (DS) (recommended cross-section of remote monitoring max.1 mm2) |
AC: 250 V / 0,5 A, DC: 250 V / 0,1 A |
|
Lifetime |
min. 100 000 h |
|
Weight |
m |
1125 g |
Article number |
10 632 |